 |
 |
 |
 |
 |
 |
 |
 |
|
|||||||||||
|
|
|
|
|
|
|
|
|
#15
11-01-2015, 03:04 PM
|
|||
|
|||
|
A bit red faced, but it turns out that if I plug one of the drives directly into one of my MBP's USB ports, everything is fine (including the presence of eject buttons and the availability of the "When you connect" option in SD!).
The problem is only fully replicable if I plug a drive into my D-Link 7-port powered USB hub, and subsequently the hub into my MBP. I know this set up of launching SD! when one of these same drives was connected via the D-Link had actually worked before, but I cannot be sure when it stopped working. My guess is the install of El Cap but, again, I'm not sure. Anyway, thought I better post back with the final solution in case anyone encounters this going forward. Thanks again, Dave. 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| repair permissions greyed out after using super duper | agentfive | General | 1 | 06-22-2012 02:55 PM |
| Action buttons greyed out | nickatwork | General | 3 | 01-05-2010 03:24 PM |
| Destination sparse image greyed out? | Breeze | General | 9 | 07-17-2009 05:51 AM |
| All SuperDuper options reset and greyed out | jpotisch | General | 3 | 12-16-2008 01:47 PM |
| Drop-downs greyed out; cannot select | RogParish | General | 3 | 10-02-2008 11:49 PM |
Threaded Mode