 |
 |
 |
 |
 |
 |
 |
 |
|
|||||||||||
|
|
|
|
|
|
|
|
|
#1
11-29-2005, 08:31 PM
|
|||
|
|||
|
SuperDuper can't find my hard drive...
When I start SuperDuper (1.5.5 or 2.0.1) it complains that it can't find the "source volume" which happens to be my internal HD (so I know it is there).
After dismissing the error message I can choose it in the pop-up. I then try and save the settings but next time I start SuperDuper I get the same error. Interestingly, after getting the initial error I can load a settings file and it works OK. This started earlier in the week when I cloned my external drive back onto a new internal which had been installed in my Powerbook (thankyou SuperDuper for allowing me to keep working through a complete hard drive failure  Any ideas? Regards, Adrian 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Hard drive size needed for backup? | Hoosier_1701 | General | 8 | 05-20-2006 07:49 AM |
| Partitioning Backup hard drive??? | Lee | General | 13 | 11-30-2005 10:32 AM |
| Hard drive recommendation / backing up PB 17' | Loopy C | General | 3 | 10-28-2005 10:47 AM |
| Partition an external hard drive problem | andrew_aes | General | 1 | 05-25-2005 07:45 AM |
| PowerMac G5 won't recognize SuperDuper Backup on External FW Drive | BobbyMiller | General | 7 | 05-12-2005 11:53 AM |
Threaded Mode